AST Rollcages V1 Removable Bolt-In 6-Point Roll Cage for Mitsubishi Lancer Evo 4 (IV) Nissan#Datsun Made in the United States

Made in the United States the AEM injection rails are made entirely of forged aluminum and are installed in place of the existing one thanks to the fitting accessories supplied

They are to be used at both ends of the Accusump so as to prevent any distortion of the tube

Artec Dump Pipe SpecificationsManufactured by Artec in Australia this cast stainless steel dump pipe (also known as an outlet pipe or elbow) allows the highest flow of all the products available on the market for Mitsubishi 4G63T engines from Lancer Evolution IV (4) to IX (9)

These bearings are sold in complete sets (for a complete engine)

AST Rollcages V1 Removable Bolt-In 6-Point Roll Cage for Mitsubishi Lancer Evo 4 (IV) Nissan#Datsun Made in the United StatesAST Roll Cages SpecificationsAttention : AST roll cages designed and built according to FIA Appendix J may not be approved depending on the year of preparation of your car. Indeed the safety requirements are often revised in Appendix J by the FIA. Check with your Federation Sporting Organisation for the minimum safety requirements specific to your vehicle version engine and type of event and or championship to be contested. AST roll cages have 4 to 10